This listing was posted on Professional Diversity Network.
General Engineer
Location:
Pawnee, OK
Description:
Summary There are 3 vacancies for General Engineers within the Office of Environmental Health and Engineering, Division of Facilities Management. The incumbents will coordinate the provision of engineering services in the areas of operational support, new construction and the repair and renovation of federal and tribal health facilities within the Oklahoma Area. Available locations are Pawnee, Clinton, Claremore, Lawton and Okc Area Office. These positions will report to Supervisory General Engineer. Duties Coordinates the provision of engineering services in the area of operational support, new construction and the repair and renovation of federal and tribal health facilities. Develops standard operating procedures and guidelines using best practices. Provides guidance to Engineers, Facility Managers and Facility Management Department trades staff. Coordinates urgent and emergency contract assistance for emergency service repairs. Develops drawing and specifications for simple to complex projects involving heating, ventilation, air conditioning, plumbing, fire protection, architectural systems, electrical distribution and medical gases. **This position is open until filled.** Requirements Conditions of Employment Selectee may be subject to a probationary periodU.S. Citizenship is requiredSelective Service Registration is required for males born after 12/31/1959Measles and Rubella immunization required for selectees born after 1957 and seasonal influenza immunization is required for all staff working in Indian Health Service health care facilities.COVID-19 vaccination is required for all selectees prior to entrance on duty.Successfully pass the E-Verify employment verification check. To learn more about E-Verify, including your rights and responsibilities, visit . Background Investigation : If you are selected for this vacancy, you must undergo a pre-employment fingerprint check and background investigation. Fingerprint results and background investigation documentation must be cleared prior to hire. After you begin your employment, your continued employment is contingent upon the outcome of a complete background investigation as determined by the sensitivity level of your position. The investigation must find that you are suitable for Federal employment in your position. If you are found not suitable, you will be terminated after you begin work. If you make a false statement in any part of your application, you may not be hired; you may be fired after you begin work; or subject to possible criminal charges. You may be subject to a credit check as a part of the background investigation process. Qualifications To qualify for this position, your resume must state sufficient experience and/or education, to perform the duties of the specific position for which you are applying.Experience refers to paid and unpaid experience, including volunteer work done through National Service programs (e.g., Peace Corps, AmeriCorps) and other organizations (e.g., professional; philanthropic; religious; spiritual; community; social). You will receive credit for all qualifying experience, including volunteer and part time experience. You must clearly identify the duties and responsibilities in each position held and the total number of hours per week. BASIC REQUIREMENT(S) : A. Degree: Engineering. To be acceptable, the program must: (1) lead to a bachelor's degree in a school of engineering with at least one program accredited by ABET; or (2) include differential and integral calculus and courses (more advanced than first-year physics and chemistry) in five of the following seven areas of engineering science or physics: (a) statics, dynamics; (b) strength of materials (stress-strain relationships); (c) fluid mechanics, hydraulics; (d) thermodynamics; (e) electrical fields and circuits; (f) nature and properties of materials (relating particle and aggregate structure to properties); and (g) any other comparable area of fundamental engineering science or physics, such as optics, heat transfer, soil mechanics, or electronics. OR B. Combination of education and experience -- college-level education, training, and/or technical experience that furnished (1) a thorough knowledge of the physical and mathematical sciences underlying engineering, and (2) a good understanding, both theoretical and practical, of the engineering sciences and techniques and their applications to one of the branches of engineering.The adequacy of such background must be demonstrated by one of the following:1. Professional registration or licensure-Current registration as an Engineer Intern (EI), Engineer in Training (EIT)1, or licensure as a Professional Engineer (PE) by any State, the District of Columbia, Guam, or Puerto Rico. Absent other means of qualifying under this standard, those applicants who achieved such registration by means other than written test (e.g., State grandfather or eminence provisions) are eligible only for positions that are within or closely related to the specialty field of their registration. For example, an applicant who attains registration through a State Board's eminence provision as a manufacturing engineer typically would be rated eligible only for manufacturing engineering positions.2. Written Test-Evidence of having successfully passed the Fundamentals of Engineering (FE) examination or any other written test required for professional registration by an engineering licensure board in the various States, the District of Columbia, Guam, and Puerto Rico.3. Specified academic courses-Successful completion of at least 60 semester hours of courses in the physical, mathematical, and engineering sciences and that included the courses specified in the basic requirements under paragraph A.4. Related curriculum-Successful completion of a curriculum leading to a bachelor's degree in an appropriate scientific field, e.g., engineering technology, physics, chemistry, architecture, computer science, mathematics, hydrology, or geology, may be accepted in lieu of a bachelor's degree in engineering, provided the applicant has had at least 1 year of professional engineering experience acquired under professional engineering supervision and guidance.In addition, to the Basic Requirements, you must also meet the Minimum Qualifications stated below- MINIMUM QUALIFICATIONS: Your resume must demonstrate qualifying specialized experience equivalent to the next lower grade and/or education as stated below for the grade level you are applying to. All qualifying education must be in engineering or a related field. GS-07: One year of specialized experience performing the following type of work: Utilize engineering principles, methods, and techniques; use energy conservation and computer maintenance management systems; and skill in design, cost estimating, and construction activities. OR Completion of a Bachelor's degree with Superior Academic Achievement.* OR Completion of at least one full year of graduate level education. OR Completion of a bachelor's degree AND 12 months of specialized work experience as a technician equivalent to the GS-5 grade level or higher. OR Completion of a 5-year program of study of at least 160 semester hours leading to a bachelor's degree in engineering. GS-09: One year of specialized experience performing the following type of work: Apply knowledge of construction standards and Occupational Safety and Health Administration (OSHA) guidelines to design floor plans, elevations, walls, and perform site surveys; using computer systems and computer operations to write and communicate requirements to customers on projects requirements; preparing computerized drawings and reports; interpreting and using information from various sources. OR A Master's degree or equivalent graduate degree or (2) full years of progressively higher level graduate education leading to a master's degree. OR A Bachelor's degree with Superior Academic Achievement* AND (1) year of appropriate professional experience. OR Completion of a 5-year program of study of at least 160 semester hours leading to a bachelor's degree in engineering AND one (1) year of professional specialized experience. OR A combination of graduate level education AND specialized experience that meets 100% of the qualification requirements. Qualifying graduate education must be in excess of 18 semester hours. GS-11: One year of specialized experience performing the following type of work: Prepare and administer construction project designs and layouts, specifications and estimates; prepare original designs and preliminary/final layouts; directing surveys and investigations to establish baseline data necessary to initiate design, evaluate design objectives, perform technical calculations, and identify the most economical and efficient procedures; performing scheduling and layout of operations; inspection and surveillance of materials, methods, safety and equipment used in construction; and providing professional advice to peers, non-professional administrators, or managers. OR Completion of a Ph.D. or equivalent doctoral degree or 3 full years of progressively higher-level graduate education leading to a Ph.D. OR A combination of graduate level education AND specialized experience that meets 100% of the qualification requirements for this position. Qualifying graduate education must be in excess of 36 semester hours. You must meet all qualification requirements within 30 days of the closing date of the announcement. How You Will Be Evaluated You will be evaluated for this job based on how well you meet the qualifications above. If you meet the minimum qualifications requirements for this position, your application will be evaluated and rated under Category Rating selection procedures. Once the application process is complete, a review of your qualifications will be conducted to determine if you are qualified for this job. Qualified candidates will be assigned to a quality category. The quality categories are: Best Qualified, Well Qualified, or Qualifie d. Within each of these categories, applicants eligible for veteran's preference will receive selection priority over non-preference eligibles.Please note that if, after reviewing your resume and or supporting documentation, a determination is made that you have inflated your qualifications and or experience, your category rating can and will be adjusted to more accurately reflect your abilities, or you may lose consideration for this position. Please follow all instructions carefully. Errors or omissions may affect your eligibility.To determine if you are qualified for this position, a review of your resume and supporting documentation will be made and compared against the qualifications as defined in the qualifications section of this vacancy announcement and your responses to the assessment questions. You will be rated based on the information provided in your resume (your resume must state specific duties that relate to this position) and your responses to the assessment questions will be evaluated against the duties you provided in your resume, along with your submitted documentation to determine your ability to demonstrate the following. Engineering and Technology Planning and Evaluating Technical Competence The following links below provide information on how you may be eligible for various hiring authorities. If you are a Veteran, qualified CTAP and ICTAP eligible, or an individual with a disability, please refer to the following links below for additional guidance. CTAP and ICTAP candidates will be eligible for selection priority if it is determined that they have exceeded the minimum qualifications for the position by attaining at least a "well qualified" rating of 85 out of 100. Information about CTAP and ICTAP eligibility is on the Office of Personnel Management's Workforce Restructuring Career Transition website at: . CTAP/ICTAP documentation requirements are listed in the "Required Documents" section of this announcement. Veterans, i.e. (VEOA, VRA, and 30% or more disabled) - Career Transition Assistance Program (CTAP) - Interagency Transition Assistance Program (ICTAP) - Schedule A Appointments for the Disabled - Click here to view vacancy questions: . All documents above MUST be received by 11:59 pm (Eastern Standard Time) of the closing date of, 01/15/2025, to be considered. Required Documents Resume : You are highly encouraged to use USAJOBS Resume Builder to ensure all required information is included in your Resume. If you use your own resume, curriculum vitae, or any other written form you choose then you must describe your job-related qualifications that includes beginning and ending dates for paid and non-paid work experience, hours worked per week, month and year of employment for each job title listed, annual salary, and description of job duties. Include name and address of employer; supervisor name and telephone number.Required as applicable for the purposes of specific eligibility and appointment claim(s), and position requirements: Indian Preference Applicants : If claiming Indian preference, applicants must provide a completed copy of the Form BIA-4432, "Verification of Indian Preference for Employment in the BIA and IHS Only." Indian preference will not be given unless a properly signed and dated form is submitted with your application, including any verification by an authorized Tribal Representative or BIA Official of tribal enrollment records. For detailed instructions, see form BIA-4432. Refer to BIA-4432 link: . When an Indian Preference candidate possesses Veterans preference the rules regarding Veterans preference apply under ESEP and the applicant must provide documentation in order to receive preference. Veterans Preference : If claiming Veteran's Preference provide a copy of your DD214 Form (Member 4 copy). To claim 10-Point Veterans Preference, submit a SF-15 Application () along with the appropriate supporting documentation. For additional information regarding Veterans Preference visit: . Career Transition Assistance Program (CTAP)/Interagency Career Transition Assistance Program (ICTAP) : If you are claiming CTAP/ICTAP, follow the instructions below: . Transcripts : You are encouraged to submit copies of transcripts (official or unofficial) although not required at the time of application. You must list your courses including titles, credit hours completed, and grades. Official transcripts will be required after tentative selection and prior to issuing an official job offer. Licensure, Certifications : Applicants should list their license/certifications on their resume, along with the expiration date, if applicable. Certification of licensure/certification will be required after tentative selection and prior to issuing an official job offer. Superior Academic Achievement : If claiming eligibility for Superior Academic Achievement, candidates must provide copies of transcripts (official or unofficial) must be included at the time of initial application. If unable to obtain transcripts, candidates must provide sufficient evidence to validate courses completed and credit hours earned. Eligibility is based on one of the following: Class standing - Applicants must be in the upper third of the graduating class in the college, university, or major subdivision and based on completed courses. Grade-point average (G.P.A.) - Applicants must have a G.P.A. of: a.) 3.0 or higher out of a possible 4.0 (''B" or better) as recorded on their official transcript, or as computed based on 4 years of education, or as computed based on courses completed during the final 2 years of the curriculum; or b.) 3.5 or higher out of a possible 4.0 ("B+" or better) based on the average of the required courses completed in the major field or the required courses in the major field completed during the final 2 years of the curriculum. Election to membership in a national scholastic honor society - Applicants can be considered eligible based on membership in one of the national scholastic honor societies listed here Association of College Honor Societies. Official transcripts may be required after tentative selection and prior to issuing an official job offer. You must meet the requirements of the job by 11:59 (Eastern Standard Time) of the closing date: 01/15/2025 PDN-9b207532-e551-470f-8b28-845e0108f01a
Visit Our Partner Website
This listing was posted on another website. Click here to open: Go to Professional Diversity Network
Important Safety Tips
- Always meet the employer in person.
- Avoid sharing sensitive personal and financial information.
- Avoid employment offers that require a deposit or investment.
To learn more, visit the Safety Center or click here to report this listing.
More About this Listing: General Engineer
General Engineer is a Engineering General Engineer Job at HHS Careers located in Pawnee OK. Find other listings like General Engineer by searching Oodle for Engineering General Engineer Jobs.
General Engineer is a Engineering General Engineer Job at HHS Careers located in Pawnee OK. Find other listings like General Engineer by searching Oodle for Engineering General Engineer Jobs.